Gunpla-Kun - WIP

There were parts that turned white even though they were not located at the gate or under load. 

The part that is blunt and thick at the tip of the Gundam horns, which is characteristic of Gunpla and designed to prevent piercing, was also depicted in a large size, so I removed it. 

The muzzle was blocked, so I drilled through it. 

Generally, the product has well-divided parts by color, but this part was not divided, so I removed it for now. 

Ideally, I should clean up the adhesive smudge after bonding, but... 

I will intentionally create step and proceed as if the setting had been divided from the beginning. 

Ready for painting. 

The first step was to paint surfacer. and than painted the blade of the lightsaber first for masking convenience. 

After that, I painted it glossy white. 

I applied the first mask to the shield. 

For the red and blue, I used colors that I had mixed before when building a Gundam. 

2nd masking. 

I used masking gel on the face. 

Painted yellow and over-coated sensor part. 

Masked rifle. 

And last masking. 

I painted the inside of the shield metallic gray. 

The panel-lines were painted in four colors to match each color. 

I painted the ink lines with four different colors to match the base color. 

All painting is finish. 

I also attached the back of the head part that I had made without forgetting. 

If you look at it like this, the reflector is clearly visible, but actually, once finished, the surface will face downward, so it won't be very visible. 

Done. 

That's really cute. 

However, I think this kit looks much prettier displayed like this, on a runner. 

Isn't that right? 

One drawback is that the weapons, which were painted with such care, are placed at the back and are not easily visible. 

Thanks for watching.