Mitsubishi Ki-46 Shitei III Dinah Recon Plane
1January 9, 2020started with the main landing gear, doesn't always have to be the cockpit...
2January 9, 2020can be bettered in a simple way I think, just scraped the seams...
3January 9, 2020Some scraping with the tip of a knife later...
4January 9, 2020same trick here
5January 9, 2020and this could also be made a bit better...
6February 14, 2020Resin Cockpit set.... missing and broken parts
7February 14, 2020parts fairly equal
8February 14, 2020but resin part has shrunk
9February 14, 2020Plastic part fit is ok. So time to make some hybrid cockpit parts
10February 14, 2020original cockpit section
11February 14, 2020started the rumble
12March 1, 2020ready for paint
13March 1, 2020ready for paint
14March 1, 2020ready for paint
15March 1, 2020ready for paint
16March 2, 2020prepared the flaps
17April 21, 2020Added the brake waire and some bands in tape
18April 21, 2020Lost the original part, so remade it, could be done better, but it is hardly visible in the end
19April 21, 2020ready for primer
20April 21, 2020and afterwards
21April 21, 2020rear cockpit in base colors
22April 21, 2020Front cockpit in basecolors, a lot of details to be added
23April 21, 2020Seats in basepaint
24April 21, 2020the knobs, a lot of these to go around... tried painting them first and thicken the knobs before placing them
25April 21, 202010 on this piece alone... Honey, what did you do all evening, well euh, I detailed a few mm's..
26April 21, 2020all knobs in place and touched up ...
27April 21, 2020engines ready for mounting... after mounting, hardly anything will be seen
28April 21, 2020started rivetting the wings
29April 21, 2020
30April 21, 2020
31April 23, 2020interior received some chipping and a wash
32April 23, 2020Photographer station ready for mounting
33April 23, 2020cockpit too
34April 23, 2020and the IP-panel
35April 23, 2020dryfit
36April 23, 2020dryfit
37April 23, 2020dryfit
38April 23, 2020dryfit
39April 23, 2020dryfit
40April 28, 2020for rivetting, draw the lines on the hull and wings with a pencil
41April 28, 2020then follow the lines with a rivetting tool
42April 28, 2020removed the wingtip lights
43April 28, 2020dryfit of the main clear parts, looks like an aircraft now
44April 28, 2020little distortion
45April 28, 2020here too, surprise !!!
46April 28, 2020even within a half a mm...
47April 30, 2020replacement wingtip light, basic shape, drilled a small hole and painted it red for the light
48April 30, 2020glued in place and ready to sand
49April 30, 2020underway
50April 30, 2020and ready
51April 30, 2020canopy taped in. maybe correction needed on one sticker
52April 30, 2020hopefully a better view on the rivetting
53April 30, 2020last dials added
54April 30, 2020other glass parts added
55April 30, 2020PE-plates for flap-housing added
Commentaires
2 May 2025, 03:45 -
