Hiller UH-4

1
February 1, 2020
Hull halves glued together
2
February 1, 2020
The only interior parts are the seats and console. The hull was thinned and a rear bulkhead and floor was added from styrene sheet. The seats were such rough castings they needed filler!
3
February 1, 2020
Pedals and control sticks scratched and added. Consol sanded to a more reasonable size and dials added
4
February 1, 2020
Interior painted
5
February 1, 2020
The kit just had a scribed oval for the engine louvres. These were hollowed out and new louvres cut from some scribed styrene sheet
6
February 1, 2020
New louvres installed and rear part of canopy installed (this later broke off due to handling). Extra thick panel lines filled and panel lines rescribed
7
February 1, 2020
Exhaust pipes made from brass tubing
8
February 1, 2020
The front wheel supplied with the kit was very rough and unusable. A new one was made from a 1/48 Bf109 tailwheel and some styrene sheet
9
February 1, 2020
Completed front undercarriage
10
February 1, 2020
Main undercarriage made from styrene rod and glued in place
11
February 1, 2020
The main rotors were also very rough. Some air bubbles needed filling and they needed reshaping - this is the start of the process.
12
February 2, 2020
Rotors reshaped, main rotor hub parts made from brass tube and wire, styrene tube and sheet. Still a lot of detail to add

Kommentit

7 May 2025, 09:01 -

Album info

My version of the Flying Checkpoint Hiller UH-4 seen in Destination Moon. The Unicraft kit is a very rough resin kit with no detail parts - you need to build your own rotor hub , main undercarriage and any details.

Destination Moon

50 kuvien

1:72

Meneillään

1:72 A4/V2 Prototypes (Special Armour SA72014)

1:72 Douglas DC-6B Super Cloudmaster (Heller 80315)

1:72 Pratt & Whitney R-2800 set (Engines & Things 72147)

1:72 Hiller UH-4 "Commuter" (Unicraft Models )

1:72 Hawker Hurricane Mk.IV. (AZmodel AZ7389)

1:72 Westland Lysander Mk.II (Pavla Models 72048)

Kaikki albumit

Näytä kaikki albumit »