[Fujimi] 1/24 Lamborghini Veneno - Job Log

Attach and remove seamline. but it was my mistaken.
This part should be painted matt black. 

I would not use wings. 

This part has a eject pin mark on the inside. 

I'm not going to use the wings, but I still put a drop of cyanoacrylate(loctite) to get rid of the eject pin marks. 

Water washing with mild detergent. 

I painted the inside black to block light penetration. 

However, it is impossible to paint inside these places. 

So that part had to be painted on the outside as well. 

I wiped the part that was too dirty. 

Masking... 

I paint, Momodeling gloss white surfacer. 

Masking... 

I use try colors.
R: GSI shine red.
Y: IPP orange yellow.
B: Turquoise. (custom made) 

Hint: Fluorescent yellow is required. 

Matt clear coat on the Red. 

Mask again and painting metal gray. 

Gloss clear coat. 

Polishing and Compoundin 

It was not pre-cut. 

Painting matt black. 

Painting carbon pettern with stocking on the painted semi gloss black. 

Brush painting and use panel line accent. 

Decal applied. 

Ready to assemble. 

1st, assemble the wheels. 

Since the lower plate was curved, I checked the floating part by putting the wheels on it. (No problem) 

Engine built. 

Assemble interior. 

The wipers may come off when assembling the windshield, so I glued them in beforehand.
The marked part will float when the windshield is combined with the body shell, so it is better to attach it beforehand. 

The crosshairs pin in the manual did not actually exist. 

The marked part does not adhere. 

In the meantime, the adhesive adhered to the body surface.
After it was completely dried, it was polished with sandpaper and compounded. 

It turned out that the marked part was the attaching point.
It would have been nice if it was well explained in the manual.
However, nevertheless, it does not fully adhere to the A-pillar. 

This is aurora beads. 

As a mirror surface, a metal sticker was cut and used. 

The left tail lamp that was attached from the inside fell off.

Since the body shell and the lower plate are firmly attached, it is impossible to recover.
However, at first, it took me a long time to figure out which part was missing, so I deliberately showed it to the people around me without explaining it, and they were not conscious of it at all. 

This x-shaped strut bar can only be attached at this stage. 

Opened door and cowl.
But I always finish with the door closed. 

Finish 

Finish 

Finish